Picture Framing for Photographers - Part 2

There are two sources for obtaining the moulding for making a frame. You can firstly start with a straight piece of timber, and using a home routing system make your own moulding shape with a rebate to take the art work. Alternatively you can pick from a large range of ready finished mouldings available from your local frame shop or hardware store. I recommend the latter. It's easier, the choice is much wider, and it's more cost effective. However, one word of warning. Always look for a moulding with a good straight back and not too flat on the surface. If the moulding has a bump or some raised section in the top surface it will cut and join easier than a flat moulding. Most mouldings are made from pine or obeche. These are soft grain timbers and cut and join well. Hard timbers like ramin are more difficult to work with.

Measuring and Cutting

How much moulding will you need? The outside dimensions of the frame are determined by the size of the mounted photograph. Carefully measure the overall size of the matted picture you're framing, adding a little extra (3-smm) for "play" to ensure the picture fits easily into the finished frame.

Add the length and the breadth together, then double the total. This will give you the overall length. But you also have to allow for the mitre cuts, so multiply the width of the moulding by 10 and add this to your total (total length required = 2 x (length + breadth) + 10 x width of moulding). The 45 mitre cuts are most important - a bad cut will never join properly and will always look terrible. There are a number of machines on the market for cutting 45 degree mitres starting with the simple mitre box, radial arm saw with a mitre attachment, or a commercial mitre saw (see picture 1).

Cutting one side of a frame is easy. Cutting the second side to be EXACTLY the same side to the first side is the hard part of frame cutting. Using a measuring system you can cut lengths accurately every time. The FrameCo measuring system will attach to any brand of electric or manual mitre saw and will make the cutting of the frames quick and foolproof.

If you have a saw you can cut without using a measuring system. Follow this easy step-by-step guide to cut mitred lengths for your frame:

* Calculate the dimensions of your frame.

* Place the moulding into the saw.

? Cut off a small piece at 45 degrees with the saw in the lefthand position.

* Remove the moulding from the saw.

? With a tape, measure along the back of the moulding, to the length you require.

To this length you have to take into account the size of the moulding you are using. So you add to the length of the side an amount equal to twice the moulding width - not including the rebate. Then make a pencil mark on the back of the moulding near the top so that you can see the mark.

? Put the moulding back in the saw and align the saw blade on the pencil mark.

? Swing the saw around and cut the next mitre.

? Place the two pieces back to back so you can transfer the size you have just cut to the back of the moulding length.

? Repeat the cutting procedure for the other pieces.

Joining the Frame

To ensure a tight and stable joint, glue should be applied, especially if the frame is large. A light smear of a good quality PVA glue is all that's necessary. Although it is possible to buy clamps that join two corners at a time, it's simpler and quicker to clamp all four corners at once. This allows you to see how the corners match up before gluing and securing the mitres. There are several types of clamps...

Cord Clamps: This simple, but effective clamping system works well for small to medium-size frames. It consists of four flexible plastic corners and a length of cord. (See picture 2).

Metal Strap Clamp: This clamping system is slightly more sophisticated and consists of a metal strap, flexible corner pieces and a screw operated tensioning device which allows you to apply a considerable amount of tension so that the corners are pulled together tightly. The Strap Clamp is suitable for large and small frames. (See picture 3).

Once the frame is clamped together and you've made sure all the corners are aligned, then the mitre joint should be secured or reinforced. Glue alone is not safe and secure enough for most sized frames. Here are some options.

Panel Pins: You can nail a panel pin across the mitre. It is advisable to pre-drill the holes and secure the joint in a vice before hammering the pins into the frame. Punch home the nail head and fill the hole with a coloured woodfiller.

V-Nails: Professional framers use these v-shaped staples, which are inserted using a special manual or pneumatic joining machine. The "PushMaster" is a DIY version of these machines and is suitable for low-volume high-quality framing such as required for photography or portrait framing.

Biscuit Joints: More suitable for large and heavy frames such as mirrors. Most commercial picture frame mouldings are small and a biscuit joint is not necessary.

V-Nail Joining Machines There are several models of these machines and all are suitable for the DIY or low-volume picture framing. Here are some of the models.

PushMaster: Similar to a large punch, the PushMaster is a handheld, easy to use tool for inserting the v-nails into the back of timber picture frames. The vnail is loaded onto the magnetic end of the PushMaster, sharp end down, then simply pushed into the wood. The v-nail pulls the joint together because it is made from spring steel. The advantage of the PushMaster is that it doubles as a fitting up tool. The magnetic tip can also be used to fit flexipoints and backing nails to secure the picture into the frame. (See picture 4).

BenchMaster: The BenchMaster is ideal for the serious DIY framing photographer. The powerful cam action of the handle combined with the heavy duty Push Master drives v-nails into the hardest of timbers. Its gentle hand action suits joining small or odd-shaped mouldings. If you start with FrameCo's Push Master you can upgrade to the BenchMaster at any time. (See picture 5).

V-Nails - How Do They Work?

Upon entering the wood moulding from the base, the sides of the metal v-nail are deflected outwards. As the v-nail pulls back into its original shape this pulls the joint tightly together. There is a little curl on the outer leading edge of the nail that locks the nail into the grain of the timber. This stops the nail from pulling out of the end of the mitre, keeping the joint stable and secure. The v-nail method of joining is the preferred method of professional picture framers. With a few simple hand tools it's possible to achieve the same result with a minimal outlay in machinery.

Making Multi-sided Frames

With most good quality suspension type mitre saws there's always the possibility of cutting mitre angles other than 45 degrees. The problem is that the saws do not have a system of measuring the length of the cut. The FrameCo measuring system has a clever scale included with the unit. It allows you to measure a length for any angle. A six-sided frame has the six mitres cut at 30 degrees, while an eight-sided frame has the eight mitres cut at 22.5 degrees. The Measure Mate Scale converts the measuring system into a multi-angled scale so that each one of these different angled mitres can be measured.

So it's possible for the amateur framer to make attractive multiangled frames that add style and creativity to your framing.

Finishing and Assembly

Now that the frame is joined and the glue joints dry you're ready to assemble your mounted photograph into the frame. The PushMaster can be used to fit backing nails or flexipoints into the frame to hold the picture into the rebate.

Seal the back of the picture with gummed tape or good quality backing tape. The best backing tape to use is a silicone coated tape as this will not peel off over time.

Screw two small O-rings or screw eyes into the side of the frame, approximately one third of the distance down the top of the frame, then attach a length of wire or cord securely through the O-rings or screw eyes. After that, your image is ready to hang on a wall.

Gary Leete, of Frameco Picture Framing Supplies, is a professional framer. For further information on any of the his DIY picture framing tools contact FrameCo P/L Australia, Ph: (03) 98723600 or visit the web site at http://www.clubframeco.com

---

Digital Camera Metering

Looking at the most intricate details of the digital camera as a technologically advanced device a lot of functions come into play. Such s a point is... Read More

The Advantages of Underwater Camera Housing

You will need an underwater camera housing to keep your valuable camera dry. This is a very important piece of equipment.When shopping for underwater camera housings, you... Read More

How Many Megapixels Do We Need?

Are you having megapixel envy each time you walk by the camera section of your favorite electronics store? So do I. But, do we really need more... Read More

Nikon Digital Cameras - Cool(pix) and Functional

Even though Nikon entered the camera world by 1948, today its digital cameras are well known everywhere. The company started small but always dreamed big. Here is... Read More

10 MORE Ways to Make Money with Your Digital Cameras

1. Pet photos - advertise a Pet Photography business where you photograph pets with their owners. Most owners won't struggle to take a photograph with their pet... Read More

Digital Film Processing is Really the Only Option for Truly Quality Prints

Digital photography has taken off like wildfire these days, primarily due to its ease and quality in its digital film processing. With a good digital camera, it's... Read More

Canadas Digital Cameras, Digital Camcorders and Cheap Memory Cards Canada

Digital SLR Camera or Digital single-lens reflex (SLR) camera is an ideal camera for professionals and amateur photographers. They usually having interchangeable lenses and are known for... Read More

Digital Camera Printers

The digital camera is not meant only for capturing images and storing them on the computer memory disks. The real effect comes from the hard copy of... Read More

How to Take Great Photos of Your Child

Children are naturally photogenic. Ive worked in studios and children are so easy to photograph. What I hear from parents is that they dont think that their... Read More

Taking Panoramic Landscapes - The Easy Solution

I love panoramas. There's something very appealing about their shape. It's probably because we see the world more in these dimensions than the near square format of... Read More

Underwater Photography: The Wonders Under the Sea

The world of photography is an amazing one. It's been with us for quite a while now but it is constantly changing. Cameras are changing and improving.... Read More

Stitching Memories

Sometimes, usual photographs look so common and boring. Converting your pictures into charcoal or oil painting is a welcome change but then, a lot of people have... Read More

The Primer on Digital Camera Printers

Once you have clicked photos through your digital camera, then the next step is to turn these 'virtual' images into real photos. One way is to send... Read More

Digital Cameras vs. Film Cameras- the debate goes on

One of the biggest debates in the photography world is whether digital cameras are better or film cameras better? The answer to this question cannot be answered... Read More

How to Buy a Digital Camera

Are you buying your first digital camera? Well, you must be confused by the bewildering range of models out there. How do you know which model will... Read More

Have You Read Your Digital Camera Manual?

Have you read the manual that came with your digital camera? If not you are in good company, the majority of digital camera owners never get past... Read More

Tips for Purchasing a Digital Camera Lens

Your lens is an essential element to good photographs. It's not just your camera. People spend thousands of dollars on a good camera and neglect the lens.Change... Read More

How to Shoot Video of Your Kids Sports Team So That Anyone Else Will Watch It!

Break out that video camera, there is a game this weekend! 1. You bought a video camera 2. You want to shoot sports of your kid 3.... Read More

Picture Framing for Photographers - Part 1

Imagine being able to frame all your own photographs just as well as a professional. You can save enough money to easily pay for all the necessary... Read More

Pinhole Photography: Right Back to Basics

Why Pinhole Photography?It's fun. It's creative. It's educative about the basics that photographers deal with whenever they do their thing.What is Pinhole Photography?At its simplest, a pinhole... Read More

Photography: The Basics

Photography comes from the Greek words meaning "light writing" and first became known back in 1839 by Sir John Herschel. For many years prior to this, people... Read More

Digital Camera Basics

Digital Camera Basics? The VocabularyShopping for a digital camera can be a difficult task considering the sheer number of choices out there. The number of manufacturers, models,... Read More

How to take Great Photos of Your Pet

We all love our animals. They do such funny, adorable, and cute things. But somehow when that camera comes out they run and hide or they just... Read More

Digital Camera Auto Exposure and Auto Focus

The digital camera being a fantastic and technologically advanced device contains many different applications of its own. Many users of this fabulous device are unaware of quite... Read More

How to Easily Start Up Your Own New Photography Business From Home

With modern technology in the form of SLR digital cameras, you do not even need the room for a dark room. You need only to have a... Read More

The Naked Truth on Shooting Nudes

There are major obstacles to overcome to get into nude photography, not least of which is the need to practise technique. By its very nature there has... Read More